Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - berwick

Pages: [1]
1
Boat Refrigeration / Compressor conversion
« on: March 19, 2015, 07:18:24 pm »
Probably a stupid question but here goes. I have a dual holding plate spillover system that is run by a 115 V/AC Tecumseh AE2415A compressor (1525 BTU, 1/3 HP) All the other stuff (dryer, gauges etc) are mounted on the compressor chassis. For various reasons I want to switch to a 12 volt system. Without tearing the fridge apart for the holding plates (not sure even how it was done) I would like to change the compressor to a 12 volt one but still use all the old stuff.
Can this be done?
If so any suggestions?

Thanks
Richard

Pages: [1]